Feedback

Move sheet in/out on VR

Move sheet in/out on VR

by Greg • over 4 years ago

SUGGESTED BY (Benjamin Phillips): Would be nice to have the sheet in/out controls for each sail moved to the triggers and middle figure trigger as it very hard to steer the yacht and sheet in too

Upvoted by (2)

Related Posts

Adjusting twist of sails2Let the sheet slip and use your teethcomplete1Handing over mainsheet and rudder5Tell Tales on Sailscomplete9More control on setup1Add percentages to sheets to indicate 0%-100% in and out3The Yacht can't be tacked and sheet in Jib at the same time.1

Comments (6)

You must be logged in to leave a comment.
Greg • over 4 years ago

Comment by: Teepee Young

I grab the wheel with my left hand and trim with both hands. Tricky though.

PappaRazzi • over 4 years ago

Not sure if triggers are the way to go, but not being able to trim the jib and steer at the same time definitely doesn't work well.

bot33 • over 4 years ago

Sometimes it works for me and sometimes not. Markolus said in Discord that it only works when the wheel is hard over, and I think that might be the key - you have to be really sure that you put the wheel right before you start wiggling the jib sheet.
Or you can use the pointer on the winch, but that is a bit too fiddly for me.